Project introduction

The CSU8RF2112 mixer, using the button operation, 4 LED lights display.

Working principle: using the SCR control, angle control motor speed withdifferent guide.

Function description and the matters needing attention

1, the machine has 1 buttons and 4 LED lights, the key is the "switch" button,LED lights are the power light, 1 stalls, 2 stalls, 3 stalls;

2, before using this machine, please make sure that the stirring rod is firmly installed, the socket insert the plug into the AC220V/50Hz, the power indicator light, the machine is in the OFF file location.

3, the various ingredients in a mixing bowl, the stirring rod is deeply in raw material. Press the key to choose the appropriate gear, with 1 stalls, 2 stalls, 3 stalls, stalls OFF circulation regulation, 1 stalls, 2 stalls, 3 stalls speedincreased in turn, press to open the key to the appropriate speed. This machine has three stalls, start with a low speed, and then slowly to the high speed, so as to avoid raw fly out. In addition to press to open the key after more than 3 minutes automatic shutdown.

4, the machine each time shall not exceed 3 minutes, then the machine needs to pause for 20 minutes, so that the machine can cool down, so as to avoidoverheating and damage to the machine.

5, in the mixing process, should try to avoid food raw material through stirring rod jack into the inside of the machine.

In 6, adding the raw material into a bowl, put forward from the mixing bowl stir bar, or each of the stirring rod is placed in a mixing bowl before, please ensure that the file to OFF file location;

7, before replacing stir bar, please unplug the power plug.

8, a brief stop, can will shift to the OFF file location, without pulling out thestirring rod, placed upright on the table.

9, in the assembly of the stirring rod, remove the stirring rod, or clean the machine, please make sure to unplug the power plug, the machine is idle,please unplug the power plug.

Schematic diagram